Porter-Cable PXCM201, Instruction Manual

5 -  ENG



DANGER

Ensure that all wiring is done by a licensed 
electrician, in accordance with the National  
Electrical code.

RISK OF BURSTING.

Air Tank: On February 26, 2002, the U.S. Consumer Product Safety Commission pub-
lished Release # 02-108 concerning air compressor tank safety:
Air compressor receiver tanks do not have an infinite life. Tank life is dependent upon 
several factors, some of which include operating conditions, ambient conditions, proper 
installations, field modifications, and the level of maintenance. The exact effect of these 
factors on air receiver life is difficult to predict.
If proper maintenance procedures are not followed, internal corrosion to the inner wall of 
the air receiver tank can cause the air tank to unexpectedly rupture allowing pressurized 
air to suddenly and forcefully escape, posing risk of injury to consumers.
Your compressor air tank must be removed from service by the end of the year shown on 
your tank warning label.
The following conditions could lead to a weakening of the air tank, and result in a violent 
air tank explosion:

WHAT CAN HAPPEN

HOW TO PREVENT IT

 •  Failure to properly drain condensed water 

from air tank, causing rust and thinning of 
the steel air tank.

 •  Drain air tank daily or after each use. If air 

tank develops a leak, replace it immediately 
with a new air tank or replace the entire 
compressor.

 •  Modifications or attempted repairs to the 

air tank.

 •  Never drill into, weld or make any 

modifications to the air tank or its 
attachments. Never attempt to repair a 
damaged or leaking air tank. Replace with a 
new air tank.

 •  Unauthorized modifications to the safety 

valve, or any other components which 
control air tank pressure.

 •  The air tank is designed to withstand 

specific operating pressures. Never make 
adjustments or parts substitutions to alter the 
factory set operating pressures.



WARNING

1. Drain the moisture from the tank on a daily basis. A clean, dry tank will help prevent 
corrosion.

2. Pull the pressure relief valve ring daily to ensure that the valve is functioning properly, 
and to clear the valve of any possible obstructions.

3. To provide proper ventilation for cooling, the compressor must be kept a minimum of 12 
inches (31 cm) from the nearest wall, in a well–ventilated area.

4. To prevent damage to tank and compressor on stationary models, the tank must be 
shimmed so the pump base is level within 1/8”  to distribute oil properly. All feet must be 
supported, shimming where necessary, prior to attaching to the floor. Fasten all feet to 
floor. We also recommend the use of vibration pads (094-0137) under tank feet.

5. Fasten the compressor down securely if transporting is necessary. Pressure must be 
released from the tank before transporting.