10- ENG
I
DangeR
Improper installation of the grounding plug can
result in a risk of electric shock. If repair or replacement of the
cord or plug is necessary, do not connect the grounding wire to
either flat blade terminal. the wire insulation having an outer
surface that is green with or without yellow stripes is the
grounding wire.
This product is for use on a nominal 115 volt circuit. A cord with a grounding
plug, as shown here, shall be used.
Make sure that the product is connected to an outlet having the same
configuration as the plug (see
Fig. 4). No adapter should be used with this
product.
Check with a licensed electrician if the grounding instructions are not completely
understood, or if in doubt as to whether the product is properly grounded. Do
not modify the plug provided; if it will not fit the outlet, have the proper outlet
installed by a licensed electrician.
foR PeRManently connecteD MoDels oR MoDels sHIPPeD
wItHout PoweR coRD:
This product must be connected to a grounded
metallic, permanent wiring system, or an equipment grounding terminal or lead
on the product.
Grounded Outlet
Box
Grounded Outlet
Plug
Plug
Grounding Pin
Fig. 4
115V
230V
230 VOLT
15 AMP
115 VOLT
15 AMP
MotoR Reset swItcH anD wIRIng
I
waRnIng
ensure that all guards and shrouds are in place before
pressing the reset switch to restart the motor.
If the motor shuts down because of overload, wait 10–15 minutes so the motor
can cool down, then press (NEVER force) the reset switch (see
a
) to restart the
motor (see
Fig. 5).
Summary of Contents for PXCM301
