6- ENG
ASSEMBLY
1. Unpack the air compressor. Inspect the unit for damage. If the unit has been
damaged in transit, contact the carrier and complete a damage claim. Do
this immediately because there are time limitations to damage claims.
The carton should contain:
• air compressor
• operator/parts manual
2. Check the compressor’s serial label to ensure that you have received the
model ordered, and that it has the required pressure rating for its intended
use.
3. Locate the compressor according to the following guidelines:
a. Position the compressor near a grounded electrical outlet (see
GROUNDING INSTRUCTIONS).
Avoid using an extension cord
; use a
longer hose instead.
b. The compressor must be at least 12 inches (31 cm) from any wall or
obstruction, in a clean, well-ventilated area, to ensure sufficient air flow
and cooling.
c. In cold climates, store portable compressors in a heated building when
not in use. This will reduce problems with motor starting and freezing of
water condensation.
d. The compressor must be level to ensure proper drainage of the moisture
in the tank.
4. Connect an air hose (not included) to the manifold outlet.
WARNING
CALIFORNIA PROPOSITION 65 WARNING:
This product contains chemicals
known to the State of California to cause cancer, birth defects and/or
reproductive harm.
SPECIFICATION CHART
MODEL NO.
RUNNING
H.P.
TANK
CAPACITY
GALLONS
VOLTAGE/
AMPS/
PHASE
KICK-IN
PRESSURE
KICK-OUT
PRESSURE
PXCM302
1.7
30 (113,6)
120
15
1
135
(9,3 bar)
165
(11,4 bar)
PXCM302_E108930_manual-rev-A_0415_v25.indd 6
4/8/15 4:21 PM
Summary of Contents for PXCM302
Page 16: ...16 ENG PARTS DRAWING...
Page 37: ...37 FR DESSIN DES PI CES...
Page 59: ...59 SP ESQUEMA DE LA PIEZAS...
Page 67: ...67 SP...
