14- ENG
DAILY STARTUP
(Figure 5)
1. Check the oil level in the pump (see "Checking the Oil" in maintenance section).
2. Turn the pressure switch to the OFF position (A).
3. Close the tank drain valve (B).
4. Plug in the power cord (C).
High temperatures are generated by the electric motor
and the pump. To prevent burns or other injuries, DO NOT
touch the compressor while it is running. Allow it to cool
before handling or servicing.
Keep children away from the compressor at all times.
5. Turn the pressure switch to the AUTO position (D).
When adjusting from a higher to a lower pressure, turn
the knob counterclockwise past the desired setting,
then turn clockwise to reach the desired pressure.
Do not exceed operating pressure of the tool or accessory being used.
6. Adjust the air pressure regulator to the working pressure of the tool being used.
SHUTDOWN
(Figure 5)
1. Turn the pressure switch to the OFF position (A).
2. Unplug the power cord (C).
3. Reduce pressure in the tank through the outlet hose. You can also pull the
relief valve ring (E) and keep it open to relieve pressure in the tank.
4. Drain water from air tank by opening drain valve (counterclockwise) on bottom
of tank (B).
Escaping air and moisture can propel debris that may
cause eye injury. Wear safety goggles when opening drain
valve.
Figure 5
E
D
A
OPEN
CLOSE
B
C
Summary of Contents for PXCML224VW
Page 23: ...26 ENG ...
Page 47: ...53 SP ...
