5
598-1169-05
testing
1.
turn on the circuit breaker and light switch.
Note: Sensor has a 1
1
/
2
minute warm up period
before it will detect motion. When first turned on
wait 1
1
/
2
minutes.
Note: Meets the ENERGY STAR
®
guidelines when
D
ual
B
rite
®
function is off.
2. Set the ON-TIME switch to the TEST position
and the D
ual
B
rite
®
switch to the OFF position.
3. Walk through the coverage area noting where
you are when the lights turn on. In TEST mode,
light will stay on for only 5 seconds then turn
off.
4. Adjust the SENSITIVITY to increase or decrease
the range as needed. Too much sensitivity may
cause false triggering due to heat sources in the
coverage area (see Adjustment of Coverage
Area or Troubleshooting section).
It is also possible to wire two motion sensing lights so
that either fixture will turn on both lights at the same
time (dual master system). It is recommended that only
people with electrical wiring experience attempt this
configuration. Please call our customer service number
(1-800-858-8501 - English Speaking Only) before
attempting this wiring.
if the dual controlled wiring
is not done correctly, it can destroy both motion
sensing fixtures and void your warranty.
instaLL Fixture Base to
Junction Box
1. Push wires into the junction box.
2. Slide light fixture base onto fixture screws and
tighten decorative nuts snugly against the base.
3. Install four candelabra base light bulbs
(25
watts maximum each)
.
4. Refer to TESTING section before installing
cover.
5. After switches are set and testing is complete,
use the 2 decorative nuts to install the cover.
DU
AL
BR
ITE
®
ON
-TI
ME
TEST
1
5 10 MI
N
OFF
3
6
D
USK
TO
DA
WN
DualBrite
®
ON-TIME
DUSK
OFF 3
HR
6
HR
TO DAWN
TEST 1 5 10 MIN
Sensor
Lens
5. Set the amount of ON-TIME you want the light
to stay on after motion is detected (1, 5, or 10
minutes).
6. Set the amount of time you want the light to
stay on in the Accent mode (Off, 3 hours, 6
hours, or dusk-to-dawn).
SEN
SITIVITY
+
–
+
–
SENSITIVITY
DU
AL
BR
ITE
®
ON
-TI
ME
TEST
1
5 10 MI
N
OFF
3
6
D
USK
TO
DA
WN
Fixture Screw
Junction Box
Decorative Nut
25 Watt Candelabra
Base Bulb
Maximum Range
C o v e r a g e
Angle*
(Top View)
360°
30 Feet (9.1 m)
in all Directions
* Without lens shield installed.
8 ft. (2.4 m)
