background image

R

INSTRUCTION

MANUAL 

XT-R

Flush mounted 
radio receiver

Technical data:

Nominal voltage:

230V, 50Hz

Nominal current:

5A

Ambient temperature:

-25 to +85

Dimensions:

44 mm x 44 mm x 25 mm

PORTOS Sp.J.
ul. Z

łota 71

62 - 800 Kalisz
tel. +48 62 768 40 00
sekretariat@portosrolety.pl
www.portosrolety.pl

Controller functions:

The device allows to control one 
tubular motor. It has a built-in 
receiver compatible with all 433 
MHz PORTOS radio transmitters 
and a possibility to attach 

pushbutton

*

. The controller can be 

installed in a gang box.

* only pushbutton without support 
and the possibility to press 
simultaneously both buttons

Setting switch

Summary of Contents for XT-R

Page 1: ...lisz tel 48 62 768 40 00 sekretariat portosrolety pl www portosrolety pl Controller functions The device allows to control one tubular motor It has a built in receiver compatible with all 433 MHz PORTOS radio transmitters and a possibility to attach a pushbutton The controller can be installed in a gang box only pushbutton without support and the possibility to press simultaneously both buttons Se...

Page 2: ...f the roller shutter and finishes the programming procedure LED and beep switch off st Removing the controller settings from a particular channel 1 method the receiver needs to be programmed already 1 Choose the channel on the remote that You want to remove the receiver from 2 Switch on the powers supply to the receiver confirms with short movement 3 Press the P2 button on the particular channel o...

Page 3: ...e remote the motor confirms by short movement of the roller shutter and finishes the resetting rd Resetting the receiver 2 method 1 Press the setting switch on the receiver for 3 5 seconds The device enters the resetting procedure LED flashes andYou can hear a beep 2 Press again the setting switch on the receiver for 5 seconds The device finishes the resetting procedure LED and beep switch off Res...

Page 4: ...llows the instruction manual The following diameter of wires are to be used when installing the controller 1 5 2 5 mm2 for the power supply 0 75 1 5 mm2 for installing the tubular motor 0 75 mm2 for local switch CAUTION General safety regulations need to be taken into account when installing the device A switch pushbutton cannot be connected to the motor parallel to the controller only via the dev...

Reviews: