Portsmith Peripheral-to-Ethernet Adapter Manual
4
• Next, click on Windows Explorer and select the
four files shown in the adjacent window:
(1) USBMode.cpl, (2) USBMode.exe,
(3) bvd_udc_ser.dll and (4) USBPSMDM.dll.
To select all four files at one time, press the
CTRL key as you left-click on each file’s name.
When finished, all four files will be highlighted.
• Now, drag and drop all four files to the
/Windows
folder on the MC50. The
bvd_udc_ser.dll
file should automatically
overwrite the older file. If prompted to overwrite
the existing file, select YES and continue.
If you have problems getting the new version to
replace the old version, then try it again.
• After you have successfully copied all four files to ?Windows, the MC50 must be rest (soft reset).
Step 6: Configuring the USB Mode.
To use the USB client modem on the MC50, go to
Start>Settings>System>USB Mode
.
• Select
Enable Host Mode Only
• Check
Load modem driver at startup
• Check
Set host mode on port open
• Tap
OK
in the upper right corner of the MC50 display screen
Step 7: Finishing Up
• Place the MC50 into its cradle and connect the MC50 USB cable to the PS6U1UPE device with the
USB Adapter Cable as described in the next section.
NOTE:
From this point on, Host mode will be enabled whenever COM9 is opened.
