System Overview
FUDA3-S1x22 Series Panel PC User’s Manual
1-9
1.5 Safety Instruction
Caution:
This section should be carefully read and please abide by the instructions for
your own safety and correct use of the unit.
The chapter also includes information on approval and interference inhibition of your
unit. Please abide by the warnings and instructions on the unit and in the manual.
The FUDA3-S1x22 Series Panel PC was built and tested by Portwell, Inc. in
accordance with and kept the company within under perfectly safe condition.
In order to retain this condition and ensure safe operation, the users must abide by
the instructions and warnings
The unit must be used in accordance with the instructions of usage.
The electrical installations in the room must not violate the requirements of the
local (country-specific) regulations.
Pay careful attention that there are no cables, especially power cables, in areas that
people can go over them.
Only use the power cord supplied as specification. Don’t use damaged power
cords.
Hints for DC power connection:
The DC power source should be able to be switched
off and on via an isolating switch. The unit is only completely disconnected from the
DC main power source when the DC power cord is disconnected either from the
power source or the unit. Therefore, the DC power cord and its connectors must
always remain within reach. The Power source should be SELV or from the
secondary circuits are circuits where separation from MAINS CIRCUITS is achieved
by a transformer in which the primary windings are separated from the secondary
windings by REINFORCED INSULATION, DOUBLE INSULATION, or a screen
connected to the PROTECTIVE CONDUCTOR TERMINAL
Hints for AC power connection via external AC/DC adapter:
The main power cable
of the optional external AC/DC adapter serves as disconnecting device. For this
reason the outlet of the AC power source must be located near to the device and easy
to reach.
Never place the unit under direct sunlight, near heat sources or in a humid place.
Make sure the unit has proper ventilation.
All plugs on the connection cables must be screwed or locked to the housing.
FUDA3-S1x22 Series Panel PC is designed to be used on the desk or upright with
the I/O interfaces downwards.
The unit generates heat under operation condition. Make sure it is properly
ventilated. Never cover up the air intake and exhaust openings of the unit. Do not
impede the fins of the heat sink.
Be aware of the warm surface of heat sink at back side. A protective wear is
recommended.
