5
55
5----3 BIOS Setting
3 BIOS Setting
3 BIOS Setting
3 BIOS Setting
It is assumed that users have correctly adopted modules and connected all the
device cables required before turning on AT power. CPU, CPU fan, CPU fan
power cable, 168-pin SDRAM, keyboard, mouse, floppy drive, IDE hard disk,
printer, VGA connector, device power cables, ATX accessories or P8/P9 power
cable are good examples that deserve attention. With no assurance of properly
and correctly accommodating these modules and devices, it is very possible to
encounter system failures that result in malfunction of any device.
To make sure that you have a successful start with ROBO-698, it is
recommended, when going with the boot-up sequence, to hit “DEL” key and
enter the BIOS setup menu to tune up a stable BIOS configuration so that you
can wake up your system far well.
Loading the default optimal setting
!"#$
% !" & '( % &#
%' %&
!"& ) & %#*
!"&%%'''
+#
Auto Detect Hard Disks
!" ,- " ./!" ( %
)%0"%/0"1 2 # "
2*#$ %%
( 21 '& %'#
Improper disable operation
There are too many occasions where users disable, in BIOS setup, a certain
device/feature in one application, but do not enable it before manipulating with
another application where the disabled device is needed. Certainly, users fail to
detect this device/feature and end up with system failure.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
