- 27 -
Rev. 1.50
A10plus MiniPrinter
CONFIDENTIAL
ESC 3
[Name]
Set line spacing
[Format]
ASCII
ESC 3
n
Hex
1B
33
n
Decimal
27
51
n
[Range]
0
≤
n
≤ 255
[Default]
Printers other than the above: Amount of line spacing which corresponds to
“default line spacing.” (See
ESC 2
for the default line spacing.)
[Description] Sets the line spacing to
n
× (vertical or horizontal motion unit).
[Notes]
■ The maximum line spacing is 1016 mm {40 inches}.
If the specified amount exceeds 1016 mm {40 inches},
the line spacing is automatically set to 1016 mm {40 inches}.
■ When standard mode is selected, the vertical motion unit is used.
■ When page mode is selected, the vertical or horizontal motion unit is used for
the print direction set by
ESC T
.
• When the starting position is set to the upper left or lower right of the print area
using
ESC T
, the vertical motion unit is used.
• When the starting position is set to the upper right or lower left of the print area
using
ESC T
, the horizontal motion unit is used.
■ The line spacing can be set independently in standard mode and in page mode.
• In standard mode this command sets the line spacing of standard mode.
• In page mode this command sets the line spacing of page mode.
■ When the motion unit is changed after the line spacing is set, the line spacing
setting does not change.
■ Selected line spacing is effective until
ESC 2
is executed,
ESC @
is executed,
the printer is reset, or the power is turned off.
