>>
Replacing Field Replaceable Units (FRUS)
THIS CHAPTER PROVIDES INSTRUCTIONS FOR REPLACING FRUS.
THE FOLLOWING TOPICS ARE DESCRIBED.
- Safety and precautions
- Before you begin
- Replacing parts
Safety and precautions
Computer components and electronic circuit boards can be damaged by discharges of static electricity.
Working on computers that are still connected to a power supply can be extremely dangerous.
Follow these guidelines to avoid damage to the computer or injury to yourself.
- Always disconnect the unit from the power outlet.
- Leave all components inside the static-proof packaging that they ship with until they are ready for installation.
- After replacing optional devices, make sure all screws, springs, or other small parts are in place and are not left loose inside the case.
- Metallic parts or metal flakes can cause electrical shorts.
- Only qualified personnel should perform repairs on the SlimPOS.
Damage due to unauthorized servicing is not covered by the warranty.
- If the LCD breaks and fluid gets onto your hands or into your eyes, immediately wash with water and seek medical attention.
- Under no circumstances touch the inverter card while power is connected to the ECP-6500M.
Unplug the power cord before attempting to replace any FRU.
- To prevent static damage to components, wear a grounded wrist strap.
Alternatively, discharge any static electricity by touching the bare metal chassis of the unit case, or the bare metal body of
any other grounded appliance.
- Hold electronic circuit boards by the edges only.
Do not touch the components on the board unless it is necessary to do so. Do not flex or stress the circuitboard.
Do not hold components such as a processor by its pins; hold it by the edges.
△
!
CAUTION
47
6
Summary of Contents for SlimPOS
