POSH SPEAKER SYSTEMS, INC., 7865 NE Day Road West, Building C, Bainbridge Island, WA 98110
Phone: 800-841-8501 • Fax 206-842-0494 • info@poshspeakers.com
Fig.
Fig.
Fig.
Fig.
Fig. 1
1
1
1
1
Installation Guide
Posh 810 Series speakers are packed two per
carton. The contents of each carton is shown at
the right. The speakers are fully assembled and
ready for installation. Installation can be easily
accomplished with a few simple steps.
528-810 Series Speakers
Carefully fit and gently tap the grill pins
into the four friction fittings on the mud ring.
(See Figure 3)
Connect the appropriate wattage tap and
common wire (refer to label inside J-box) as
needed for your installation. Wiring connections
must be made in accordance with all applicable
national, regional, or local codes. Clip unused
wires. (See Figure 2)
With the support rails mounted to the can,
center the speaker mud ring over the hole.
Set it in place into the ceiling grid. The
support rails may be safety wired, if required.
(See Figure 2)
Mount the supplied support rails to opposing
sides of the back can using two #10 sheet
metal screws. (See Figure 1)
Using the supplied template, cut a 10.0 inch
(25.4 cm) round hole in the ceiling tile where the
speaker will be installed.
(1) installation guide
(2) speaker assemblies (speaker, baffle, and backcan)
(2) speaker grilles
(4) support rails (2 per speaker assembly)
(1) cardboard template
Contents of carton
Step 4
Step 4
Step 4
Step 4
Step 4
Step 5
Step 5
Step 5
Step 5
Step 5
Step 3
Step 3
Step 3
Step 3
Step 3
Step 2
Step 2
Step 2
Step 2
Step 2
Step 1
Step 1
Step 1
Step 1
Step 1
Fig.
Fig.
Fig.
Fig.
Fig. 2
2
2
2
2
Fig.
Fig.
Fig.
Fig.
Fig. 3
3
3
3
3
Support
rails
Tie down
Purple
Red
Gray
Blue
Yellow
Black
70v
1.25w
2.5w
5.0w
7.5w
15.0w
Common
100v
2.5w
5.0w
10.2w
15.0w
Do not use
Common
Purple
Red
Gray
Blue
Yellow
Black
70v
1.25w
2.5w
5.0w
7.5w
15.0w
Common
100v
2.5w
5.0w
10.2w
15.0w
Do not use
Common
5288100702
Speaker Systems, Inc.
