Page 10
replace the used up UPS battery at power off as soon as possible.
Emergency treatment:
The battery is constructed maintenance free and leakproof. Its storage
space in HT/PB-3600 system also provides very good protection as long as the
ambient temperature remains below 30
°
C and the ventilation of the HT system
remains free. However, should any accident happen and the sulfuric acid from
the battery spills on skin or clothing, wash immediately with water. If the acid
comes in contact with eyes, rinse eyes with large amount of clean water and
see a doctor immediately. A larger external battery may be connected to give
an extended operation. Please check your dealer about this capability when
required.
WARNING:
If there are any signs of over charging or leakage of electrolyte
please contact your dealer immediately
VGA Display Port
The VGA port in the HT/PB-3600 terminal supports a 12 volt DC power to the
external (secondary) monitor through the VGA signal cable after proper
internal setting change. This may cause permanent damage to any other
monitor not designed to use this facility. Please use only a Posiflex LM-2010
monitor designed for the HT system. Consult your dealer if you have any
doubt. It is strongly advised that connection/disconnection to this port should
never take place when system power is ON. The video memory shares from
the system memory. The video memory size shares system memory 128MB up.
Note: 12 volt DC power is available on pin 9 of the VGA connector and
can be available through BIOS setting.
Serial Port – COM1
Please always occupy COM1 serial port by a suitable serial device or this
terminator. If this port is left vacant or connected with something like a mouse,
the power switch management and the cash drawer control may fail to work
correctly. As well as an RS232 MODEM is not applicable to this port.
LED INDICATORS (for HT-3600 only)
On bottom rim center of HT-3600 system cashier LCD panel, there are 2 LED
indicators. The LED at right indicates the LAN status. When it lights up in
green, the onboard LAN chip is linked. When it flashes in yellow, data
transmission in LAN is in process. The LAN status indication is also
observable on the LAN connector in main connection area. The LED at left