Page 11
indicates Power/Stand-By status.
POWER ON/OFF CONTROL
The HT/PB-3600 terminal implements electronic power control, such that the
main power to the system may be controlled by many methods as below:
1.
Hardware power switch
2.
Software OFF command
3.
Automatic power ON control
4.
Emergency power OFF
Hardware Power Switch
This button is located at bottom front corner of right side
as in right picture and can be used to turn the system on
and off alternatively. When this option is installed, this
hardware switch can also be programmed to be an ON
only switch through software command so that when this switch is accidentally
pressed during system turned on, the system just remains on and unaffected.
Software Off Command
The system may also be shut down under software control. Please just follow
the arrangement by your system integrator for this capability.
Automatic Power On Control
The system may also turn on according to some preset conditions such as
Modem Ring Up and LAN Wake Up. To utilize Modem Ring Up function,
please enter the CMOS setup by pressing “F2” key at system boot up, choose
for “Other Control” in “Power” and make the “Resume on Modem Ring” ON
for Modem Ring Up. Save the configuration and exit the CMOS setup program.
The Preset Power on Control will then be ready after a normal power off. For
LAN wakeup, an operating caller system connected through LAN to the
system is required. It also requires a qualified networking technician to check
the LAN chip ID of the HT/PB-3600 system for the caller system to wake it up.
When the HT/PB-3600 system is turned off after a successful boot up, the
preset automatic power on functions will keep monitoring for the preset
conditions and turn on the system when the preset conditions are met.
Please note that if the HT/PB-3600 system is improperly turned off before a
complete boot up procedure, the above preset power on control functions will
be disabled until next turning off after a complete boot up.
