Page 13
interval, it will simulate double-clicking left button of the mouse.
Touch terminal manager
Before using the resistive type touch control panel, dual-touch function can be
apply if you connect any Posiflex USB controlled touch monitor to the VGA
port of HT-3600 system for extended secondary display application.
A program named “Posiflex Touch Terminal Manager” is installed in the
preloaded Windows system for the user to maneuver versatile features of the
touch terminal with a touch panel controller. This program can also be
obtained by download from the
POSIFLEX
web site
http://www.posiflex.com
.
Conversely, the installation process of this driver for Windows system requires
some careful attention to the notice messages.
With proper setup and selection on control items in “Posiflex Touch Terminal
Manager”, a drawing representing a 2-button mouse will appear on the desktop.
Touch the right button in this drawing. Any touch on the screen after this
action will result in a right button mouse click at the point touched. After
touching the left button in this drawing the screen touch will resume the left
button function. This program also controls the beep generated when the touch
panel is touched, the detail in right button click emulation, and also provides
touch panel re-calibration. In principal, the touch panel requires no further
calibration once properly set.
USB touch manager
A program named “Posiflex USB Touch Manager” and a right-click sticky
button tool in the program group “Posiflex USB Touch Tools” is installed in
the preloaded Windows system if a USB interface touch panel controller is
installed.
CUSTOMER DISPLAY
The optional customer display mounted on a pole at rear corner of HT/PB-
3600 system can be turned horizontally or vertically for best viewing effect in
application.
USB
There are 5 standard USB connectors in the rear I/O plate. All support the
Universal Serial Bus Specification standard 2.0 and also 1.1. If for any reason
these ports has to be limited as USB 1.1 only, please enter BIOS setup and go
to “Integrated Peripherals” then “Onboard Device” and disable the item “USB
2.0 Controller” and enable it back afterwards.
