HT-4600/PB-4600 series Technical Manual 58
IMPORTANT! Please read first before proceeding with RAID installation
When using RAID option for the first time, or when both HDD connecting to RAID
board are new, RAID control board needs to be manually reset.
In the scenario where a RAID upgrade kit is being installed to the system that already
has the HDD, this existing HDD must get installed to the right side and then the 2
nd
HDD should be installed to the left side.
The reason for this restriction is because after RAID control board is reset, it will
duplicate image from HDD0 to HDD1. It in no doubt that if there is no data in the
original HDD and then above restriction does not apply.
Firstly, please power on the system and wait for the first beep sound (during BIOS
POST) press the switch 1 of the RAID Control Board for 5 seconds. Restart the
system by pressing “Ctrl + Alt + Del”. Reset is successful if “External Disk 0” is
detected. If this message is not seen, please repeat the reset step again.
COM 5/6 INSTALLATION
For the installation of HT-022 COM 5/6 adaptor board, please connect the cable to the
HT-022 first as lower left picture. Next, please fix these 2 com ports to the reserved
holes in I/O plate and fasten the Hex screws which circled in the lower middle picture.
After that, please connect the other side of cable to the main board which shows in the
lower right picture. For more detail of connectors, please refer to the prior chapter
“HARDWARE DETAIL”