KS-6615 / KS-6617 series Technical Manual 7 - 2
BASE MOUNT UPGRADE KIT
This upgrade is applicable to Jiva KS system with base stand in desktop
application. On rear edge of the stand assembly,
there is a rear connect cover as marked in the right
picture. This area is designed for installing a 12”
2nd LCD display panel option LM-6201 or a 15”
2
nd
LCD display monitor LM-6301 or a low
profile LCD customer display option PD-305 or a
LCD customer pole display option PD-306 or PD-
306U or PD-7622 or a VFD customer pole display option PD-2501 or PD-2602 after
this cover removed. Press the arrowed center part of the cover to remove it for the
installation. Should there be difficulty removing it, please check if there is any locking
screw nearby the center part of the cover.
Please note that for KS-6617, there could be much more restrictions to the tilt
angle range for the main unit due to larger dimensions of the LCD panel if base mount
upgrade kit mounted. Investigation for the acceptability of such kind of restrictions
must be taken before decision to install a base mount upgrade kit to these models.
Fit the joint base of PD-2501, PD-2602, PD-305, PD-306/U, PD-7622 or LM-
6201 or the interface bracket of LM-6301 to the rear
connect cover opening. Fit 2 screws with washers to
hold the joint tight as in the picture at right. Then
insert the cable into the base mount device cable
groove and cable holder on bottom plate and connect
to the main unit through the base. For low profile
customer display PD-305, the display unit is right on
joint base without the pole. Remember to enable the
+5 V DC supply in the COM port of the main unit for
PD-2501, PD-2602, PD-305, PD-306 or PD-7622 or the +12 V DC in VGA port for
LM-6201 or LM-6301. PD-306U will be powered through the USB port without
specific setting.
The family of rear mount upgrade kits may keep growing with time, the
installation principle will remain as to install the kit base or the connecting bracket to
