Part 12
plastic latchkey that is used when removing the cable cover, but be sure to turn
it in the clockwise direction to lock the cover in place. Re-adjust the tilt angle
of the screen for best viewing.
Connect the cables to appropriate external devices through the cable
exit at the bottom of stand assembly. Please make sure that each connector has
to be connected to the right device in the right way.
CAUTION: On doing any insertion or extraction of any connector, please
always hold the connector head itself instead of pulling on the
cable wire. Failure to do this could damage the cable and jack
that is considered as an artificial destruction and is not
covered by the warranty.
OPERATING SYSTEM RECOVERY
For Jiva TP/LT-5600/5700, if not using a remote boot operating
system, the operating system exists in the Compact Flash Card. Therefore,
once the Compact Flash is damaged for any reason, the thin client may fail to
boot.
A bootable new Compact Flash Card will be required to have the
workstation back to work
. Please follow instructions given by the System
Integrator to deal with situations like that. One more advice for CF Card
application is that in spite of the fact that it is used in the way like an ordinary
HDD, usual system management utilities such as
FDISK.EXE or
FORMAT.COM shall never be used on CF Card
otherwise the boot sector
of operating system itself may be damaged and causing the CF Card no longer
bootable.
For Jiva TP/LT-5800/8000, the preloaded operating system exists in
the HDD in base. Once the software system on HDD collapses, it is possible to
restore the operating system onto a physically intact HDD with use of the
Recovery CD that comes with the preloaded operating system. Please follow
the instruction from your system integrator for system / software restoration.
Follow the instructions below for operating system recovery only if your
system integrator does not advise otherwise.
For the Jiva TP/LT-5800/8000 preloaded with Windows XP Pro or
WEPOS on HDD, Posiflex provides recovery CD delivered with the touch
terminal for the preloaded operating system. The System Integrator shall take
care of software restoration after OS recovered. A Posiflex supplied USB
interface CDROM drive or the internal type IDE interface CDROM drive with
the cable kit mentioned earlier will be required for such action. Other brand
CDROM drive may require its specific driver different from what supported in
the recovery CD.
Please use the recovery CD in rescue operation only. Using it
otherwise may wipe out whatever stored in the HDD!
All upgrade devices
drivers needed for manual installation in usual way are available in the
