Part 8
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system,
all the cable connections have to be routed through its base, either slim or
universal. Therefore, please observe the procedures from A to C below to
separate the main unit from both slim and universal base stand assembly after
all cables in cable cover disconnected.
OPENING STAND ASSEMBLY
Take the adjustable stand assembly and turn it up side down to show
the bottom of the base. Remove the bottom plate fixing screw and push the
bottom plate aside as in left picture below for slim base and the middle picture
for universal base to open.
Take the bottom plate up and the inside of an example slim base
model looks like this in the above right picture. The inside of an example
universal base model will look like the picture on next page. Both with
numbered items listed on next page. However, there could be some variation to
the contents inside depending on what option items actually installed.
Step A:
Prepare a soft clean flat surface, such
as a piece of cloth on the desk to seat
the front surface of main unit
Step C:
Slide the base stand assembly to left to
separate the main unit from base stand
C
A
B
C
A
B
Step B:
Press the Lock/Release button for
main unit detach and meantime ...
Bottom Plate
Fixing Screw
Push Bottom
Plate This Way
To Open
Universal base bottom
6
2
5
4
12
1
2
11
3
2
Inside slim base
7
Slim base bottom
Bottom Plate
Fixing Screw
Push Bottom
Plate This
Way To Open
Auxiliary
Cable Exit