KS-6810 series Technical Manual 20
AUTOMATIC POWER ON CONTROL
When the system is turned off after a successful boot up, the preset automatic power
on functions if set as below will keep monitoring for the preset conditions and turn on
the system when the preset conditions are met.
Please note that if the system is improperly turned off before a complete boot up
procedure, the above preset power on control functions will be disabled until next
turning off after a complete boot up.
ALARM CLOCK WAKE UP
To utilize Alarm Clock Wake Up function, the user should enter the CMOS setup by
pressing “Del” key at system boot up, make the “Resume by Alarm” in “Power
Management Setup” enabled and set the alarm to required time. Save the
configuration and exit the CMOS setup program. The Preset Power On Control will
then be ready.
MODEM RING UP
To utilize Modem Ring Up function, the user should enter the CMOS setup by
pressing “Del” key at system boot up, make the “Wake-Up by Ring/LAN” in “Power
Management Setup” enabled and connect the RS232 modem to any COM port. Save
the configuration and exit the CMOS setup program. The Preset Power On Control
will then be ready.
LAN WAKE UP
The LAN Wake Up function is supported under pure DOS environment only. It is not
applicable to Windows DOS or Command Prompt Mode. In this application, there
needs to be 1 master machine and 1 target machine connected together through LAN.
Both machines should be using same brand of LAN chip.
