Part 7
INSTALLATION GUIDES
CAUTION: Before any installation or cable connection to the set, please
always make certain that the system is turned off and the
external power source to the set is removed to prevent electric
hazard! Never touch any metal pin in the connectors or
circuits to avoid high voltage hazard or electrostatic discharge
damage unless the operator is well grounded. Failure to do the
above will void the product warranty!
TECHNICAL MANEUVERS
Some technical maneuvers in KS-6815 series such as serial COM port
+5V power supply settings and VGA port +12V power supply setting are
supported in system BIOS setting. However, such support is limited to the
application of specific Posiflex peripherals and must be disabled when the
Posiflex peripherals are disconnected.
Failure to follow the discipline would
result in electric or fire hazard and such consequences are not covered by
product warranty!
To manipulate each of these functions please select
“Integrated Peripherals” in system BIOS setup and enter “SB GPIO Control”.
The rest applicable technical maneuvers include system CMOS data
reset, system reset, DRAM upgrades, physical access to CF memory card if the
CF card reader option is installed and installation of optional SATA HDD in
base, optional RAID function reset. All these technical maneuver operations
require purchase of applicable Technical Manual from Posiflex or consultation
from Posiflex authorized dealers and should be handled only by a
qualified
technician
.
OPENING CABLE COVER
Please follow steps A to C sequentially with reference to pictures
below to remove the cable cover for both slim and universal base models.
Step A:
Push lock/release lever for tilt angle adjust
backward
Step B:
Turn panel backward to most horizontal position
Step C:
Pull at the removal hollow
toward the user
Tips:
If there is trouble removing
the cable cover, try pressing
the arrowed portion of cable cover in the rear
view picture at right at the same time.
C
A
B
