Part 9
INSTALLING UPS BATTERY (OPTION)
When the KS-6815 system is ordered with the UPS battery, the UPS
battery is separately stored in the carton at delivery. Please take the battery out
and place it into the battery compartment by first putting in the end of UPS
battery without cable in the UPS battery end hold of the base and have the end
of UPS battery with cable held against the UPS battery stopper in the base as
indicated in picture above. route the UPS battery cable to reach for main unit
through the cable passage in the base. Apply the bottom plate and screws the
UPS battery will be held in place. Connect the UPS battery to UPS battery
connector of the main unit
only when the system is about to power up for
operation
.
Always disconnect the UPS battery
when the system is to be left
powered off for more than few days. Please pay particular attention to the
environment requirement for UPS battery in next chapter “USING THE
TOUCH TERMINAL”.
CABLE PASSAGE FROM BOTTOM
Please route all cables through the cable passage to main unit in
desktop mount application. Hold them together with a cable tie. Pass all cables
other than those for optional HDD kit in base or optional UPS battery through
the cable exit to external connections.
BASE MOUNT UPGRADE KIT
On rear edge of the stand assembly for desktop
mount application, there is a rear connect cover. Either a 2nd
LCD display panel option LM-6101 or a LCD or VFD
customer display option such as PD-305 or PD-306 or PD-
2501 or PD-2602 can be installed here after removing this
cover. The rear connect cover can be removed easily by
pushing the plastic hook plate at center of it from top side.
1. Cable Exit
3. Cable Tie for Option HDD Cables
2. UPS Battery Stopper
4. Cable Passage To Main Unit For
Desktop Mount Application
6. Option HDD Conversion Board
7. Option HDD Bracket
5. UPS Battery End Hold
3
4
2
7
6
Inside base bottom
1
5
