Part 7
TILTING LCD PANEL
The tilting mechanism for this terminal utilizes hinges and
there is no particular skill to turn the LCD panel to most
suitable angle for either viewing or convenience in cable
connection / disconnection.
DISCONNECTING ALL CABLES
With the LCD panel turned to most backward position, the main I/O connector
area will be easily accessible at bottom side of the main unit. Please
first note
orientations of every existing cable connection
and then disconnect every
cable properly before any further reconfiguration of cable connections.
Please note that the click lock spring has to be pressed down prior to pulling
out the connector such as the LAN port or the CR port or the alternate RJ45
form COM3/4 port. Please also note that the fixing screws have to be loosened
free prior to disconnection such as the 2 regular DB9 form COM ports or the
VGA port. Please
always hold the connector head
instead of pulling on the
cable wire when disconnecting any connector. Failure to do this could damage
the cable and jack that is considered as an
artificial destruction. Damages
due to incorrect disconnection operation are not covered by product
warranty!
OPENING BASE BACK COVER
In order to settle the touch
terminal properly in a point
of sale system, all the cable
connections have to be
routed through its base.
Therefore, please observe the side view pictures of the base trunk at the left
and release the triangle marked hooks to remove the back cover.
