Part 4
C.
Cable Connections
In order to settle the touch monitor properly in a point of sale system, all the
cable connections have to be routed through its base. Therefore, please observe
the procedures from A to C below to separate the main unit from the base
stand assembly after all cables in connection area disconnected.
Refer to the bottom view picture of the
separated base at left, pass all cable through the dash
lined tunnel under a steel plate. Open the steel plate if
necessary by removing the 2 triangle marked screws.
Insert the rectangular marked end first when
reinstalling the steel plate.
Hook the main unit back onto base stand assembly by matching the matching
pegs to round part of matching holes and slide them down to slot part till the
rear lock/release button clicks.
Connect the VGA cable, USB cable (type B connector) and power cable to the
I/O connection area of LM-/TM-7115/7115N. Connect up to 2 USB devices to
LM-/TM-7115/7115N at the type A connectors. Please note that unlike usual
USB HUB, these USB devices won’t be recognized by the host when LM-
/TM-7115/7115N is powered off.
Step A:
Prepare a soft clean flat surface, such
as a piece of cloth on the desk to seat
the front surface of main unit
Step C:
Slide the base stand assembly to the
right to separate the main unit from base
d
C
A
B
Step B:
Press the Lock/Release button for
main unit detach and meantime ...
Matching Holes
Matching Pegs
Round Part
Slot Part
