18
9.
To hold the power cord into place, attach the screw hole of
power cord holder to the hole at the bottom of Gen 8E base,
and then use a fixing screw to secure the power cord holder.
Installing Side Mount Upgrade Kits
Located at left side on the back of your
LCD panel, side mount compartment is
mainly used for installation of side-
mounted equipment, such as magnetic
stripe reader. For detailed installation
instructions, please refer to the user
manual specific to the device which you
intend to mount onto the terminal.
Installing Rear Top Mount Upgrade Kits
Rear top mount upgrade kits, including
customer pole displays and monitors, have
to be mounted onto the top side on the rear
of your POS terminal as shown in the
figure. As for the installation instructions
along with the individual cable
arrangement for the specific base, please
be advised to read the user manual specific
to the device you intend to install.
Installing Wall Mount Kits
The wall mount kits enable you to mount your POS terminal onto the
wall as an alternative. For detailed installation instructions, please be
advised to refer to the user manual specific to wall mount kits.
Installing an Operating System
You are highly advised not to install an operating system on XT-
5315/5515/5515Pro without professional instructions. Not only might the
careless handling during installation cause irreversible damage to your
machine, but also the improper installation likely leads to system malfunction
or failure. Please contact with your dealers about the issues of operating
system installation.
Power Cord Holder
