Instruction Manual v.
1.0
Returning for Service
Returning for Service
If you need to return the PosiTector
SHD Verifier
for service, describe the
problem fully and include reading results, if any. Be sure to include contact
information including your company name, company contact, telephone
number and fax number or email address. defelsko.com/support
The PosiTector
SHD Verifier
kit is ideal for checking the accuracy and
operation of shore hardness durometers and is an important component
in fulfilling both ISO and in-house quality control requirements.
The kit is ready to use with all PosiTector
SHD Shore Hardness
Durometers
. The Smart Sensor Indicator (SSI) has been preset, and no
additional configuration is required or recommended. If the SSI settings
are mistakenly altered, see
Reconfiguring the SSI
Device
(pg. 3).
Range:
0 - 10 lbs
Resolution:
0.001 lbs
Accuracy:
+ 0.004 lbs (+17.8 mN)
NOTE:
Device displays imperial units only.
4
Introduction
Introduction
Technical Data
Technical Data
Load
Cell
Smart Sensor Indicator (SSI)
Load Cell Cable
Limited Warranty, Sole Remedy and Limited Liability
Limited Warranty, Sole Remedy and Limited Liability
DeFelsko's sole warranty, remedy, and liability are the express limited
warranty, remedy, and limited liability that are set forth on its website:
www.defelsko.com/terms.
www.defelsko.com
© DeFelsko Corporation USA 2017. All Rights Reserved
This manual is copyrighted with all rights reserved and may not be
reproduced or transmitted, in whole or part, by any means, without
written permission from DeFelsko Corporation.
DeFelsko and PosiTector are trademarks of DeFelsko Corporation
registered in the U.S. and in other countries. Other brand or product
names are trademarks or registered trademarks of their respective
holders.
Every effort has been made to ensure that the information in this manual
is accurate. DeFelsko is not responsible for printing or clerical errors.
Verifier
DEVICE COMES COMPLETE
with load cell, smart sensor indicator,
built-in rechargeable Lithium Ion
batteries with universal AC adaptor,
replaceable Shore A (aluminum) and
Shore D (brass) targets, allen wrench,
instructions, Sample Certificate of
Accuracy, hard shell carrying case,
two Certificates of Calibration
traceable to NIST, one (1) year
warranty.
www.
.com
information@itm.com
1.800.561.8187
