OBM-U Series
4K LCD Professional Monitor
with 12G-SDI, Quad Link 4K
12
B
A
C
F
E
G
D
H
I
Rear Panel(OBM-U090)
A : SDI IN (SDI Input) connectors (BNC)
Input connectors for SDI signals. For details, see “9. Connec ng the SDI Signals” (page 32).
B : SDI OUT (SDI Output) connectors (BNC)
Output connectors for SDI signals.
Each connector outputs the signal which is input to the corresponding SDI IN connector.
**Note
- Output is ac vated only when the power is on. Output is not ac vated in standby mode.
C : HDMI Input connector
Input connector for HDMI signals.
- For an HDMI cable, High Speed HDMI Cable with the cable type logo or HDMI 2.0 Cable is recommended.
- When inpu ng 4K resolu on(3840 x 2160 or 4096 x 2160) signal, use a cable of 3m or less.
D : Analog Input connector
Input connectors for analog signals (CVBS, Component).
E : PARALLEL REMOTE connector(RJ-45, 8-pin)
Forms a parallel switch and controls the monitor externally.
**Note -
For safety, do not connect the connector for peripheral device wiring that might have excessive
voltage to this port. Follow the instruc ons about this port.
[Pin Assignment]
Func ons can be changed in [Remote] sec on of the menu.
1
8
Pin Number
Func on
Single SDI
Square SDI
2-S.I. SDI
HDMI
Analog
1:1 Scan
Power
GND
1
2
3
4
5
6
7
8