PostProcess Technologies, Inc. • www.postprocess.com • REV C | page 7
1. OPERATION
1.3.1 The FUNCTION Button
The
FUNCTION (Fn)
Button (shown below) allows the operator of the CENTI to access the functionality settings.
The CENTI
Fn
Button is disabled if the machine is running in Auto Mode. Each time the
Fn
Button is pressed, it
advances to the next setting. See the list below for corresponding settings. If no further key is pressed after 15
seconds the CENTI returns to a ready state. If changes are made, but no key is pressed after 15 seconds the
changes are saved prior to returning to a ready state.
• Press
Fn
(1X) once to
Set Temperature
• Press
Fn
(2X) twice to
Set Ultrasonics Time
• Press
Fn
(3X) three times to
Set Ultrasonic Power
• Press
Fn
(4X) four times to
Select Celsius or
Fahrenheit
• Press
Fn
(5X) five times to
Set Degas Time
Pressing the
Fn
Button once from any setting
advances the screen to the next function. The LED
icon for each function will flash when activated.
Figure 4. Function Button
1.3.2 Setting the Target Temperature
Pressing the
Fn
Button once accesses the temperature control settings. Once this is
initiated, the icon highlighted on the left of the display begins blinking. To adjust this
temperature setting, use the “
UP
” and “
DOWN
” Arrow” as shown left until the desired
temperature is reached.
The temperature displayed below the
Set Temperature
is the
Actual
Temperature
of the detergent in the tank. The icon to the right of the
actual temperature reading is the
Heater
icon. When this is displayed,
the heater is on and running.
WARNING
When operating the machine with PG1.1 detergent for SLA parts, do not allow the detergent temperature to
exceed 110°F.
