INSTALLATION MANUAL: PAD100-PSSA / PSDA PULL STATION (SINGLE & DUAL ACTION)
Document 5406320-A 02/16
Potter Electric Signal Company, LLC • St. Louis, MO • Phone: (800) 325-3936 • www.pottersignal.com
PAGE 3 OF 3
Figure 4. Examples of PAD100-PSSA / PSDA's Front Views
Notes:
•
SLC wiring style supports the Class A, Class B and Class X.
•
SLC loop wiring (SLC+, SLC-) are power limited.
•
Wiring for terminals SLC+, SLC- are supervised.
•
All wiring is between #12 (max.) and #22 (min.).
•
Wire Preparation – Strip all wires 1/4 inch from their edges as shown here:
– Stripping too much insulation may cause a ground fault.
– Stripping too little may cause a poor connection and subsequently an open circuit.
Th
ese instructions do not purport to cover all the details or variations in the equipment described, nor provide for
every possible contingency to be met in connection with installation, operation and maintenance.
Specifications subject to change without prior notification.
For Technical Assistance contact Potter Electric Signal Company at 866-956-1211.
Actual performance is based on proper application of the product by a qualified professional.
Should further information be desired or should particular problems arise, which are not covered sufficiently for
the purchaser's purpose, the matter should be referred to a distributor in your region.
1/4 inch
P
POTTER
P
POTTER
