5-85
PFC-6030 • 5403595 • REV C-1 • 10/13
LED Annunciators (LED-16)
The panel supports ten (10) LED annunciators. The LED annunciator provides sixteen (16) LEDs, which may be assigned to
a specific zone; when that zone becomes active, the LED will display the alarm, supervisory or trouble conditions. Each LED
annunciator also provides five (5) non-programmable system LEDs that annunciate the overall system condition (
Power, Earth,
Silenced, Alarm, Supervisory and Trouble
).
Note
: This panel supports up to ten (10) LED-16 annunciators and/or DRV-50 drivers in any combination.
To add and configure a LED annunciator:
1. Select the
LED -16 function
from the system panel.
2. Click the
Add Device button
. The
“Add Device” window
displays.
Figure 121. Example of the Add LED-16 Window
3. Double-click in the
“Name” field
to customize name.
4. Double-click in “
Address” field
to adjust address, if needed.
5. Repeat steps, as needed, to continue adding LED-16s.
LED Driver (DRV-50)
The panel supports up to ten (10) LED drivers. The DRV-50 provides up to 50 LED outputs, which may be mapped to any zone.
Like the LED annunciator, the LED driver provides five (5) non-programmable system LEDs that annunciate the overall system
condition (
Power, Earth, Silenced, Alarm, Supervisory and Trouble
). Additionally, the LED driver has four (4) programmable
supervised dry contact inputs.
Note
: This panel supports up to ten (10) DRV-50 drivers and/or LED-16 annunciators in any combination.
To add and configure a LED driver:
1. Select
DRV-5-
from the system panel.
2. Click the
Add Device button
. The
“Add Device” window
displays.
Figure 122. Example of the Add DRV-50 Window
3. Double-click in the
“Name” field
to customize name.
4. Double-click in “
Address” field
to adjust address, if needed.
5. Repeat steps, as needed, to continue adding DRV-50s.
