13
INSTALLATION – Page 13
Remove template and drill holes ‘A’ using a 7mm drill.
Carefully cut flue outlet hole through wall or ceiling
allowing for any horizontal flue to rise at an angle of 3
0
throughout its length.
Using wall plugs and screws from accessory pack ‘A’
attach boiler mounting plate to wall ensuring that it is level.
FIG. 8 BOILER MOUNTING PLATE
Lift the boiler onto the mounting plate and adjust vertical
alignment using the adjustment screws at the rear of the
boiler
.
Refer to FIG. 11
and secure the boiler to the
mounting plate using the MS screw from accessory pack
‘A’.
FIG. 9 LIFTING, ADJUSTING AND SECURING THE BOILER
Summary of Contents for envoy 30
