Tab. 13: Check no. heating circuit (prog.-no. 6217)
Heating circuit 3
Heating circuit 2
Heating circuit 1
0 No heating circuit
00 No heating circuit
00 No heating circuit
1 Circulation via boiler pump
01 Circulation via boiler pump
01 Circulation via boiler pump
2 Heating circuit pump
02 Heating circuit pump
02 Heating circuit pump
3 Heating circuit pump, mixing
valve
03 Heating circuit pump, mixing
valve
03 Heating circuit pump, mixing
valve
Software version
(6220)
Display of the actual software version.
8.22 LPB-system
Device address/Segment ad-
dress
(6600/6601)
The two-part LPB address of the controller consists of the 2-digit segment num-
ber and the 2-digit device number.
Bus power supply function
(6604)
-
Off
: the power supply of the bus system does not take place through the con-
troller.
-
Automatically
: the power supply of the bus system is switched on and off by
the controller depending on the power requirement of the bus system..
Bus power supply state
(6605)
-
Off
: the power supply of the bus system through the controller is currently inac-
tive.
-
On
: the power supply of the bus system through the controller is currently ac-
tive.
Display systemmessages
(6610)
This setting allows system messages which are transmitted via LPB to be sup-
pressed on connected operating elements.
Alarm delay
(6612)
Settling out of the alarm on the BM module can be delayed in the base device by
an adjustable time. This allows the prevention of unnecessary messages to a serv-
ice location from briefly occurring malfunctions (e.g. temperature monitor quer-
ied, communication errors). However, it must be realised that briefly occurring
malfunctions which continue and quickly occur again, are also filtered out with
this.
Display systemmessages
(6620)
If the setting Central is activated under progr. no. 6221 and 6223, the action for
this setting can be set. The following settings are possible:
-
Segment
: the changeover is done for all controllers in the same segment.
-
System
: the changeover is done for all controllers in the entire system (that is in
all segments). The controller must be located in segment 0!
Summer changeover
(6621)
-
Locally
: the local heating circuit is switched on and off depending on prog. no.
730, 1030 or 1330.
-
Centrally
: depending on the settings made in prog no. 6620 either the heating
circuit in the segment or in the entire system is switched on and off.
Optg mode changeover
(6623)
-
Locally
: the local heating circuit is switched on and off.
-
Centrally
: depending on the settings made in prog no. 6620 either the heating
circuit in the segment or in the entire system is switched on and off.
Programming
114
Paramount three 30-115 kW
7308272-03 03.14
Summary of Contents for Paramount 40
Page 1: ...Installation manual Gas condensing boiler Paramount three 30 115 kW ...
Page 23: ...Prior to installation 7308272 03 03 14 Paramount three 30 115 kW 23 ...
Page 25: ...Fig 5 Connection plan Prior to installation 7308272 03 03 14 Paramount three 30 115 kW 25 ...
Page 28: ...4 9 Legend Prior to installation 28 Paramount three 30 115 kW 7308272 03 03 14 ...