29
7704679.01 (3-08/18)
20.3 CHANGE LANGUAGE (Operator unit menu)
To set the language, follow the procedure indicated in section 20 and proceed as follows:
• access the
Operator unit menu
B
and select programme row
20
(Change language);
•
B
to select a language
B
to save.
•
C
to return to the previous menu.
21. FUNCTIONS ASSOCIATED WITH THE EASY MENU BUTTON (rapid menu
)
Press
A
e
B
to scroll the following functions:
•
Standby/operation
•
Hot water boost
•
Central heating mode CH1
•
Room temperature CH1
•
Hot water mode
•
Rated DHW setpoint
then
B
to enable the selected function,
B
to modify the value and
B
to confirm.
Standby/operation
If this function is enabled, appears on the display and boiler operation is disabled in the DHW and heating modes (the anti-
freeze function remains enabled). To recover boiler operation, repeat the procedure described above.
Hot Water boost
This function is used to heat the storage boiler, if fitted, until the set temperature is reached, regardless of the set time band.
Central heating mode CH1
This menu is used to select the boiler operating mode as indicated in section 16.
Room temperature CH1
Select this menu to change the comfort ambient temperature value.
DHW mode
Select this menu to enable "
On
" or disable "
Off
" DHW. The "
Eco
" function disables pre-heating (only present in boilers producing
domestic hot water).
Rated DHW setpoint
Select this menu to change the maximum DHW temperature value.
When DHW is disabled,
disappears from the display.
When the function of pre-heating is active, the symbol
is flashing even without any D.H.W. request.
22. FAULTS
A
Main fault code (see table)
B
Secondary fault code
C
Description of fault
The faults shown on the display are identified with the symbol , the information shown on the display is:
•
A fault code (
A
)
•
A secondary fault code (
B
);
•
A brief description of the fault (
C
);
•
The following symbols could appear on the display:
the meaning of which is explained in section COMMISSIONING
THE BOILER "CONTROL PANEL".
In the event of a fault, to display the main menu,
C
. The symbol remains on the display indicating that the appliance is
in the fault status. After a minute the display returns to visualise the fault screen as indicated in the figure.
Summary of Contents for Sirius Three WH-130
