Date: 2015-Oct.-24
Rev:
Page 4 of 4
6. Place the slat roll (E) in between (
A&D
) as seen in illustration below.
7. Secure the slats with (28x) Phillips Head Screw (L) through the hole at the end of the slat and into the Side rail
and Back panel as seen in illustration below.
8. Loosely tighten with a Phillips Head Screwdriver (Not included).
9. Tighten all bolts and screws to make sure all are tight and bed structure is rigid.
10. It is recommended all screws be checked from time to time for safety as the hardware may loosen over time.
11. Assembly is complete.
Care Instructions:
•
Dust often using a clean, soft, dry and lint-free cloth.
•
Blot spills immediately and wipe with a clean, damp, cloth.
•
We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
•
Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Thank you for your purchase
Stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181
L
28x
