Date: 2014-December-4
Rev:
Page 6 / 11
ASSEMBLY INSTRUCTIONS
1.
Attach Left and Right Brackets (F&G) to the Mattress Base (PART 5) using (8x) Bolt (E). Make sure the
brackets point outwards. Tighten using Allen Key (A). Note: Do not remove the metal brackets (F&G) from the
mattress base upon installation.
2.
Cover the protruding parts of the inserted Bolts (E) with the Acorn Nuts (H) at the back of the Mattress Base
and from inside of the frame, as seen in the illustration below. Tighten using Wrench (I).
3.
Place Front Gate (PART 2) on a soft and scratch-free work surface with pre-drilled holes facing upward. Attach
Left/Right End Panel (PART 3 & 4) to Front Gate (PART 2). Insert (2x) Bolt (C) through the holes at top and
bottom of each End Panel into corresponding metal inserts at top and bottom of the Front Gate as shown
below. Secure all bolts with Allen key (A). Do not fully tighten bolts (C) at this point to make installation of the
Mattress Base and the remaining Headboard easier.
2
3
4
Arrow sticker side down. Arrow points inside.
Côté avec étiquette à flèche vers le bas.
Flèche pointée vers l'intérieur.
C
2
x
4x
E
8x
F
2
x
2x
G
2
x
2x
H
8
x
8x
(G)
(F)
(F)
(G)
3
(A)
(E)
(G)
(H)
(I)
