Date: 2015-Feb-10
Page 3 of 5
Rev: 2015-Nov-27
Assembly Instruction Steps:
1. Gently remove the drawer box from Storage Base (C) and keep the drawer box for later use.
2. Connect the Storage Base (C) and Leg Panel (B) to the Stretcher (D), with the wooden dowels and pre-drilled
holes aligned, as shown in the illustration below. Make sure the oval cut-outs on the Stretcher (D) face out to the
rear side, as seen below.
3. Insert 2 sets of: Long Bolt (F), Spring Washer (H), Flat Washer (I), and Half-Moon Washer (J) from the oval
cut-outs on the two ends of the Stretcher (D) and into the posts, as see in the illustration below.
4. Secure with the supplied Allen Key (E).
Do not fully tighten
.
5. Insert 1 set of: Short Bolt (G), Spring Washer (H), and Flat Washer (I) from the pre-drilled hole on the Stretcher
(D) and into the metal insert pre-installed on the Storage Base (C).
6. Secure with Allen Key (E).
Do not fully tighten
.
C
B
D
F
H
I
J
C
F
2x
G
1x
H
3x
I
3x
J
2x
X1
X2
