Date: 04-April-04
Page 6 of 7
Rev:
8.
If the Cubby Base does not sit level, adjust the levelers underneath the legs, as seen in the illustration below
9.
Assembly is complete.
Multiple Desks can be combined together by following the assembly instructions below:
10.
Place the Desks in the desired location.
11.
Align the Desks together.
12.
Place a Mending Plate (C) over the metal insert holes on the rear side of the Desk Tops, as seen below.
13.
Insert 2 Machine Screws (D) through each of the pre-drilled holes of the Mending Plate and then into the metal
insert holes on the Desk Tops.
14.
Tighten all screws with a Phillip Head Screw Driver (not included).
UP
DOWN
4x
