Date: 2014-Sept-16
Page 7 of 10
Rev: 2015-Jan-21
Left
90
o
29. Turn the Metal Bracket (S) back into place over the ITW Toggle Bolt (T).
30. Insert the ITW Toggle Screw (U) through the hole of Metal Bracket (S) and into the ITW Toggle Bolt (T) on the
wall, as shown in the illustration below.
31. Tighten the ITW Toggle Screw (U) with a Phillips Head Screwdriver (not included).
Multiple Media Bases and Wall Hutch can be combined together by following the assembly instructions
below
.
32. Please complete the drill holes into the Side Panels
before
placing the Bridge on top of the Wide Media Base.
33. Place the
Left
Bridge down onto the floor, as shown below
34. Attach the Small Drill Bit (W) to the Power Drill (Not included).
35. From the
inside
of the Bridge, drill through the pre-drilled holes of the Side Panel in a 90-degree angle at the
locations seen below.
Please make sure to drill these pre-drilled holes gently, to prevent damage to the Side Panel. Do not push
too hard with the drill.
U
1x
W
1x
U
LEFT
