Date: 22‐Oct‐15
www. potterybarn.com
Page 4 of 8
Rev:
3. Adjusting
the
levelers:
Due to an uneven floor, the furniture may not sit level due causing it to wobble. If the furniture wobbles, determine
which corner does not touch the ground correctly. With two people follow these steps:
1) Adjust the levelers using the Allen key 4mm (e) on the interior holes of the bases until adequate contact will
be made with the floor. Gently set down the piece and check stability and door alignment.
2) Repeat steps until furniture sits firmly and the doors are properly aligned.
4. Desk assembly is complete.
To setup as the Full Office Suite, follow the steps 5-7:
5. Bore holes should be made on the exterior side panels of the desk. Using the pilot holes as a guide, bore holes
on the sides using a drill with the 5mm drill bit (enclosed in the hardware pack of the base, see separate base
instructions).
Drill
Drill
d
e
