- 10 -
9400 GB FRONT U. HECKANBAU (296)
GB
FRONT AND REAR ATTACHMENT
Additional gear for front
attachment
- A reversing gear (1) is to
be used where the p.t.o. is
540 rpm.
- A reversing step-down gear (2) is to
be used where the p.t.o. is 1000 rpm.
Fitting the gear
The respective gear is fixed directly onto the attachment
frame with an M 12 lock nut (4).
Caution!
When fitting the gear always install the hexagonal screw (5)
of the bearing fixture with the head forward.
Rear Attachment - forward travel
When not using a roller wheel (5)
• The rear-mounted TOP 380 FH can be operated without
a roller wheel. A rigid upper link (7) is necessary for this
type of operation.
• The swath is formed on the right along the direction of
travel.
Implement preparation for operation with rear
attachment - forward travel:
1. Raise implement with tractor's lifting gear.
2. Release locking mechanism (3) by pulling on rope (S2).
3. Slowly throw in the p.t.o.
This results in the curved path for tine control and the
trailing axle being rotated approx. 180°.
During this procedure, release the rope and allow the
bolts for the locking mechanism (3) to engage in the end
position (
Pos. H
) again.
4. Using the lifting gear lower the implement to the ground
and fix the trap sheet to the side where the swath is to be
formed.
5. Check: The side locking bolts must be secured in the "
E
"
position with the spring pin.
6. Check: Bolts must be in the "
HECK
" position.
If they are not in the "
HECK
" position:
• Raise implement
using lifting gear.
• Pull rope (S1)
just enough to
release locking
mechanism and
hold lever in this
position (
Pos.
"
O
").
• Lower implement
to the ground using
tractor's lifting
gear.
• Release rope
(lever in
Pos.
"
Z
").
The bolts are now in the "
HECK
" position and the
implement is ready for operation.
HECK
TD 47/94/7
FRONT
