Tractor ECU (panel:app TECU)
User
manual
EXPERT 75 - HW 1.0
60
Tractor settings: Settings can be made for tractor name, wheel and ra-
dar sensor, PTO sensor, 3-point sensor, power management and X-sen-
sor.
Speed: The number of pulses per 100 metres for the wheel and radar
sensor as well as the sensor source for the hectare counter can be set.
PTO shaft : The number of pulses per revolution can be set.
3-point linkage: The voltage values for the highest and lowest position
of the 3-point linkage can be set.
The speed, PTO shaft and 3-point linkage tabs are deactivated and cannot be selected if the
signal source for wheel or radar sensor, PTO shaft and 3-point linkage is not available in the
"Tractor settings" tab, or the signal socket is not set as the source. If the signal socket is se-
lected as the source for one of these sensors in the tractor settings, the corresponding tab is
also active and the sensor can be configured.
8.2.7.1
Overview
The first tab displays an overview of the settings for the wheel and radar sensor, PTO shaft
and 3-point linkage (cf. Illustration 8-7).
8.2.7.2
Comment
In this tab, you have the option of attaching a comment to the tractor, which contains expla-
nations or remarks about the tractor. If you select the comment field in Illustration 8-8, you
can add a new comment or change an existing one ( cf. Illustration 8-9). A maximum of 160
characters is allowed for the comment. If this number is exceeded, the text field turns red and
the entry cannot be saved.
