- 20 -
1100_GB-Power-Control_3843
GB
POWER CONTROL - OPERATION
Control panel
Display indicator:
• Main indicator
• Special menu
-
SET
(Settings for machines, setting the time differences,
setting the speed control)
-
TEST
(sensor test)
-
DATA
(software versions, operating hours)
• Alarms
Description of the buttons:
1 Raise left cutter bar
2 Lower left cutter bar
3 Raise centre cutter bar
4 Lower centre cutter bar
5 Raise right cutter bar
6 Lower right cutter bar
7 Raise all cutter bars
8 Lower all cutter bars
9 Special
menu
10 Navigation menu + Cross conveyor belt preselect
11 Navigation menu + Cross conveyor belt preselect
12 Swing cross conveyor belt out
13 Swing cross conveyor belt in
14 Cross conveyor belt speed (slow/fast)
15 Select transport position
16 STOP
17 Alter menu value (-)
18 Alter menu value (+)
19 ON / OFF
Display
When the machine is turned on, the machine’s current
status is displayed on the work screen
Power control initial operation
Switching on
operating device
- pressing the I/O button
Switch off
the control panel and job calculator by
- pressing the I/O button
Note!!
After turning off the control panel (OFF).
Move the hydraulic control valve to the O
position.
This is particularly necessary for tractors
with open hydraulic systems, otherwise oil
heating occurs.
1
2
4
6
8
3
5
7
9
12
14
10
11
16
17
13
15
18
19
Note!!
Always store
control panel in a
weather-resistant
location.
Symbol description:
1 Machine’s operating status
2 “Transport position” selection activated
3 Conveyor belt status (swung in/out)
3
2
1
Note!
The power control
may go into an
undefined state in
during a mal-
function due to
incorrect sensor
values. The pow-
er control is reset
to the normal
state by pressing
the STOP button
for 10 seconds.
This is confirmed
by means of an
acoustic signal.
The locking
hooks open if the
transport pre-se-
lection button is
activated immedi-
ately afterwards.
Then bring the
mower units back
into the working
position.
