GB
MAINTENANCE
- 64 -
0700-GB KLINGEN_3841
Take note!
Damaged, buckled
and worn out
parts must not
be used further
(danger of
accident).
Holder for a quick change of cutter blades
Attention!
For Your Safety
• Regularly check that cutter blades are tightened
firmly!
- Cutter blades on a cutter disc should wear out
simultaneously (danger of imbalance).
Otherwise they are to be replaced with new ones
(replace in pairs).
- Buckled or damaged cutter blades must not be
used further.
• Buckled, damaged and/or worn cutter blade holders
(30) should not be used further.
Checking the mowing blade suspension
- Normal check every 50 hours.
- Check more often when mowing on stony terrain or in
other difficult operating conditions.
- Check immediately after driving over a hard obstacle
(e.g. stones pieces of wood, ect).
Carry out a check
- as described in chapter „Changing the Cutter
Blades“
Changing the Cutter Blades
1. Insert lever from left or right side on the cutter disc
”Pos A” until it stops.
2. Swing lever from ”pos. A” to ”pos. B” and push the
movable holder (30) down.
3. Remove cutter blade (M)
4. Clean forage remains and dirt away.
- around the bolts (31) and inside the borehole (32)
5. Check:
• blade bolts (31) for damage, wear and fitting
• holder (30) for damage, change in position and
fitting
• borehole (32) for damage.
- Side surfaces must not show signs of
deformation
6. Install cutter blades
7. Visual check! Check that blade (M) is correctly
positioned between blade bolts (31) and holder (30)
(see diagram).
8. Swivel lever (H) to ”A” again and remove.
Pos
A
Pos
B
