Poulan Pro 191663, Owner'S Manual

8

Your new tractor has been assembled at the factory with the exception of those parts left 
unassembled for shipping purposes. To ensure safe and proper operation of your tractor 
all parts and hardware you as sem ble must be tightened securely. Use the correct tools 
as nec es sary to in sure proper tightness. Review the video cassette before you begin.

ASSEMBLY/PRE-OPERATION

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly 
easier.  Stan dard wrench sizes you need 
are listed below.
(1)  3/4" wrench              (1)  Pliers
(2)  7/16" wrench            (1)  Utility knife
(1)  Tire  pressure  gauge          
When right or left hand is mentioned in 
this man ual, it means, from your point of 
view, when you are in the op er at ing po si-
tion (seat ed be hind the steer ing wheel).

TO REMOVE TRACTOR FROM 
CARTON

UNPACK CARTON

1.   Remove all accessible loose parts and 

parts boxes from carton.

2.   Cut along dotted lines on all four pan-

els of carton. Remove end panels and 
lay side panels fl at.

3.   Check for any additional loose parts or 

cartons and remove.

BEFORE REMOVING TRACTOR 
FROM SKID

ATTACH STEERING WHEEL 

ASSEMBLE EXTENSION SHAFT AND 
BOOT
1.   Slide extension shaft onto lower steer-

ing shaft.  Align mount ing holes in ex-
tension and lower shafts and install 1/4 
hex bolt and lock nut.  Tighten securely.

IMPORTANT:

 Tighten bolt and nut se-

curely to 10-12 ft. lbs torque.
2.   Place tabs of steering boot over tab 

slots in dash and push down to secure.

INSTALL STEERING WHEEL
3.   Position front wheels of the tractor so 

they are pointing straight forward.

4.   Remove steering wheel adapter from 

steering wheel and slide adapter onto 
steer ing shaft ex ten sion.

5.   Position steering wheel so cross bars 

are hor i zon tal (left to right) and slide 
inside boot and onto adapt er.

6.   Assemble large fl at washer, 1/2 hex 

nut and tighten se cure ly.

7.   Snap steering wheel insert into center 

of steer ing wheel.

8.   Remove protective materials from trac-

 tor hood and grill.

IMPORTANT:  

Check for and remove any 

staples in skid that may puncture tires 
where tractor is to roll off skid.

02601

1/4 Locknut

Lower
Steering 
Shaft

Steering Boot

Extension Shaft

1/4 Hex Bolt

Steering 
Wheel

Insert

Adapter

1/2 Hex Nut

Large Flat Washer

Tabs

Tab
Slots

HOW TO SET UP YOUR TRACTOR

INSTALL SEAT 

Adjust seat before tightening adjustment 
knob.
1.   Remove adjustment knob and fl at 

washer securing seat to cardboard 
packing and set aside for assembly of 
seat to tractor.

2.   Pivot seat upward and remove from 

the cardboard packing. Remove the 
cardboard packing and discard.

3.   Place seat on seat pan so head of 

shoulder bolt is positioned over large 
slotted hole in pan.

4.   Push down on seat to engage shoulder 

bolt in slot and pull seat towards rear of 
tractor.

5.   Pivot seat and pan forward and as-

 sem ble adjustment knob and fl at 
washer loosely. Do not tighten.

6.   Lower seat into operating position and 

sit in seat.