Poulan Pro 192666, Owner'S Manual

22

SERVICE AND ADJUSTMENTS

TO REMOVE HOOD AND GRILL ASSEMBLY 
(See Fig. 25)

•      Raise hood.
•      Unsnap headlight wire connector.
•         Stand in front of tractor.  Grasp hood at sides, tilt toward 

engine and lift off of tractor.

•      To replace, reverse above procedure.

02778

FIG. 25

HEADLIGHT
WIRE
CONNECTOR

HOOD

TO REPLACE HEADLIGHT BULB

•      Raise hood.
•      Pull bulb holder out of the hole in the backside of the 

grill.

•      Replace bulb in holder and push bulb holder securely 

back into the hole in the backside of the grill.

•      Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run 
poorly, stop running, or prevent it from starting.
•     Check wiring.  See electrical wiring diagram in the 

Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse.  The 
fuse holder is located behind the dash.

02603

FIG. 23

FIG. 24

SEAT PAN

02602

KEPS 
NUT

HEX 
BOLT

POSITIVE (RED) 
CABLE

NEGATIVE 
(BLACK) CABLE

TER MI NAL 
COVER

ENGINE

TO AD JUST THROTTLE  CON TROL CABLE 

The throttle control has been preset at the factory and 
ad just ment should not be necessary. If adjustment is nec-
 es sary, see engine manual.

TO AD JUST CHOKE CON TROL 

The choke control has been preset at the factory and ad-
 just ment should not be necessary. If adjustment is neces-
sary, see engne manual.

TO ADJUST CARBURETOR  

Your carburetor is not adjustable. If your engine does not 
operate properly due to suspected carburetor problems, 
take your tractor to an authorized service center for repair 
and/or adjustment.

•     Connect BLACK grounding cable to negative (-) ter-

 mi nal with remaining hex bolt and keps nut. Tighten 
securely.