14
02
66
1
Attachemnt
Lift Lever
High Position
Attachment Clutch Lever
“Engaged” Position
“Disengaged”
Position
Low
Position
Defl ector
Shield
• For best cutting performance, grass over
6 inches in height should be mowed
twice. Make the fi rst cut relatively high;
the second to desired height.
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt
by the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine. You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating
or cutting off when operating your equip-
ment on rough, rolling terrain or hills.
1. Select desired height of cut.
2. Start mower blades by engaging at-
tach ment clutch control.
TO STOP MOWER BLADES -
disengage at tach ment clutch con trol.
CAUTION:
Do not operate the mower
without either the en tire grass catcher,
on mowers so equipped, or the defl ector
shield in place.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightly off the ground when
mower is at the desired cutting height in
operating position. Gauge wheels then
keep the deck in proper position to help
prevent scalping in most terrain conditions.
NOTE:
Be sure tractor is on a fl at level
surface.
1. Lower mower and adjust mower to de-
sired cutting height(See “TO AD JUST
MOWER CUT TING HEIGHT” in this
sec tion of manual).
2. Remove retainer spring and clevis pin
which secure each gauge wheel bar.
3. Lower gauge wheels to ground. Raise
gauge wheels slightly to align holes
in bracket and gauge wheel bar and
insert clevis pin. Gauge wheels should
be slightly off the ground.
4. Replace retainer spring into clevis pin.
5. Be sure all gauge wheels are in the
same setting.
IMPORTANT:
Be sure to readjust gauge
wheels if you change the cutting height
of the mower deck.
019
77
Clevis
Pin
Retainer
spring
TO OPERATE ON HILLS
WARNING
: Do not drive up or down
hills with slopes greater than 15° and do
not drive across any slope. Use the slope
guide provided at the back of this manual.
• Choose the slowest speed before start-
ing up or down hills.
• Avoid stopping or changing speed on hills.
• If slowing is necessary, move throt tle
control lever to slower position.
• If stopping is absolutely necessary, push
clutch/brake pedal quickly to brake posi-
tion and engage parking brake.
• Move motion control lever to neutral (N)
position.
IMPORTANT:
The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de pressed.
• To restart movement, slowly re lease
parking brake and clutch/brake ped al.
• Slowly move motion control lever to
slowest setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by placing
freewheel control in free wheel ing po si tion.
Freewheel control is located at the rear
drawbar of tractor.
1. Raise attachment lift to highest position
with at tach ment lift control.
2. Pull freewheel control out and down
into the slot and release so it is held in
the disengaged position.
• Do not push or tow tractor at more than
two (2) MPH.
• To re-engage transmission, reverse
above procedure.
