Poulan Pro 193747, Operator'S Manual

12

ASSEMBLE REMOTE 

THROTTLE CONTROL TO 

ENGINE (ON MODELS SO 

EQUIPPED)

(USE HARDWARE GROUP “E”)
NOTE:

 If your lawn mower does not have 

a remote throttle control, go on to
“ASSEMBLE ENGINE ZONE CONTROL 
CABLE TO ENGINE”.
•   First, move lever on remote throttle 

control to the CHOKE (if equipped) or 
FAST/START position.

CHOKE

FAST / START

Determine the manufacturer and brand or 
type engine on your lawn mower and fol-
low the appropriate in struc tions that follow.

MODELS WITH BRIGGS & STRATTON 
CLASSIC OR SPRINT AND MODELS 
WITH TECUMSEH  ENGINES:
NOTE:

  Tecumseh engines have cable 

mounting clamp and screw preassembled 
on engine.
•  At en gine carburetor, insert wire “Z” 

bend of throttle control into hole of 
speed lever (use inner hole on Briggs & 
Stratton engine).

•   (Briggs & Stratton only) Assemble di-

ecast clamp and #10 x 5/8 screw loosely 
to engine.

•  Position throttle cable under clamp and 

push cable towards speed lever until speed 
lever touches boss.  Hold cable at this po-
sition and tighten clamp screw securely.  

MODELS WITH BRIGGS & STRATTON 
QUANTUM ENGINES:

•   Slide throttle lever on engine to CHOKE 

position (away from spark plug).  Push 
gently beyond fi rst stop to lock in detent 
(CHOKE position).

•   Insert wire “Z” bend of throttle cable into 

throttle lever hole from top side.

•   Secure throttle cable to engine with 

diecast clamp and #10 x 5/8 hex head 
screw and tighten securely.

(BRIGGS & STRATTON ENGINE SHOWN)

(Clamp and Screw are preassembled on 

Tecumseh engines)

BRIGGS & STRATTON CLASSIC AND 
SPRINT EN GINES: 
•  Attach throttle cable to side of en 

gine 

housing with cable clip and #10 x 5/8 hex 
washer head screw.  Tight en securely.

Diecast 
clamp

#10 x 5/8
Hex head screw

Speed lever

Cable clip

Throttle 
cable

#10 x 5/8
Hex head screw

Throttle 
lever

Hex 
Head
Screw
#10 x 5/8 

Diecast clamp

Throttle cable