Poulan Pro 195021, Operator'S Manual

19

SERVICE AND ADJUSTMENTS

FIG. 17

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground 
or driveway.  Make sure tires are properly infl ated (See 
“PROD UCT SPECIFICATIONS” section of this manual).   If 
tires are over or underinfl ated, you will not properly adjust 
your mower.

TRACTOR

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER 

VICE OR AD 

JUST -

MENTS:
 

•

  Depress clutch/brake pedal fully and set parking brake.

•

  Place motion control lever in neutral (N) position.

•

  Place attachment clutch  in “DISENGAGED” position.

•

  Turn ignition key  to “STOP” and remove key.

•

  Make sure the blades and all moving parts have completely stopped.

•

  Disconnect spark plug wire from spark plug and place wire where it cannot come in contact  

 with 

plug.

RETAINER 
SPRINGS
(BOTH SIDES)

RE TAIN ER 
SPRINGS
(BOTH SIDES)

ELECTRIC CLUTCH PULLEY

FRONT 
LINK

SUS PEN SION
ARMS

RETAINER 
SPRING

ANTI-SWAY 
BAR

TO REMOVE MOWER (See Fig. 17)

Mower will be easier to remove from the right side of trac-
tor.
•     Place attachment clutch switch in “DISENGAGED” 

po si tion.

•     Move attachment lift lever forward to lower mower to 

its lowest position.

•      Roll belt off electric clutch pulley.
•      Disconnect  anti-sway  bar  from  chassis  bracket  by 

re mov ing re tain er spring.

•      Disconnect suspension arms from rear deck brackets 

by removing retainer springs.

•      Disconnect front links from deck by removing retainer 

springs.

•      Raise lift lever to raise suspension arms. Slide mower 

out from under tractor.

IMPORTANT:

  If an attachment other than the mower deck 

is to be mounted on the tractor, remove the front links.

TO INSTALL MOWER (See Fig. 17)

•      Raise attachment lift lever to its highest position.
•      Slide mower under tractor with defl ector shield to right 

side of tractor.

•      Lower lift lever to its lowest position.
•     Connect front links to mower deck and secure with 

retainer springs..

•     Connect suspension arms to rear deck brackets and 

secure with retainer springs.

•     Connect anti-swaybar to chassis bracket and secure 

with retainer spring.

•      Install belt into electric clutch pulley groove.

DEFLECTOR SHIELD