Poulan Pro 195021, Operator'S Manual

6

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.
(1)  3/4" wrench 

Pliers

(1)  9/16" wrench 

Tire pressure gauge

    Utility 

knife

When right or left hand is mentioned in this man ual, it means 
when you are in the operating po si tion (seated be hind the 
steer ing wheel).

TO REMOVE TRACTOR  FROM    
CAR TON

UNPACK CARTON

•      Remove all accessible loose parts and parts cartons  

from carton.

•     Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels fl at.

•     Check for any additional loose parts or cartons and 

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to insure proper tightness.

FIG. 1

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment knob.
•     Remove adjustment knob and fl at washer securing 

seat to cardboard packing and set aside for assembly 
of seat to tractor.

•         Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•    Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•      Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•      Pivot seat and pan forward and assemble adjustment 

knob and fl at washer loosely. Do not tighten.

•      Lower seat into operating position and sit on seat.
•     Slide seat until a comfortable position is reached 

which allows you to press clutch/brake pedal all the 
way down.

•      Get off seat without moving its ad just ed position.
•      Raise seat and tighten adjustment knob securely.

BEFORE REMOVING TRAC TOR FROM 
SKID

ATTACH STEERING WHEEL (See Fig. 1)

•     Remove locknut and large fl at wash er from steering 

shaft.

•      Position front wheels of the tractor so they are pointing 

straight forward.

•      Slide the steering sleeve over the steering shaft.
•     Position steering wheel so cross bars are horizontal 

(left to right) and slide onto steering wheel adapter.

•     Secure steering wheel to steering shaft with locknut 

and large fl at wash er pre vi ous ly removed.  Tight en 
securely.

•     Snap steering wheel insert into cen 

ter of steering 

wheel.

•      Remove  protective  materials  from  tractor  hood  and 

grill.

IMPORTANT:

 CHECK FOR AND REMOVE ANY STAPLES IN 

SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO 
ROLL OFF SKID.

0281

8

STEERING WHEEL 
INSERT

LOCK NUT

LARGE FLAT WASHER

STEERING 
WHEEL

STEERING 
SHAFT

STEERING 
SLEEVE

STEERING 
WHEEL ADAP-
TOR