Poulan Pro 402993, Operator'S Manual

19

SERVICE AND ADJUSTMENTS

•        

Slide mower out from under right side of tractor.

IMPORTANT:

 If an attachment other than the mower deck 

is to be mounted on the trac tor, remove the front link (E) 
and rear lift liks (C) from tractor.

A

B

C

D

FIG. 18

FIG. 19

TO INSTALL MOWER  

(See Figs. 18-21)

Be sure tractor is on level surface and engage park ing 
brake.
•      Lower attachment lift lever to it's lowest position.

CAUTION: Lift lever is spring loaded. 
Have a tight grip on lift lever, lower it 
slowly and engage in lowest position.

NOTE:

 Be sure mower side suspension arms (A) are point-

ing forward before sliding mower under tractor.
•     Slide mower under tractor until it is centered under 

tractor. 

•      ATTACH MOWER SIDE SUSPENSION ARMS (A) TO 

CHASSIS - Position hole in arm over pin (B) on outside 
of tractor chassis and secure with washer and retainer 
spring.

•      Repeat on opposite side of tractor.

•     ATTACH REAR LIFT LINKS (C) - Lift rear corner of 

mower and position slot in link assembly over pin on 
rear mower bracket (D) and secure with washer and 
retainer spring.

•      Repeat on opposite side of tractor.

•      ATTACH FRONT LINK (E) - Work from left side of trac-

tor. Insert rod end of link assembly through front hole 
in tractor front suspension bracket (F).

•      Insert end of link (E) into hole in front mower bracket 

(H) and secure with washer and retainer spring (J).

E

F

H

J

M

FIG. 20

FIG. 21

•      Push clutch cable housing guide (P) into bracket, slide 

collar (L) onto guide and secure with retainer spring 
(K).

•     Hook end of clutch cable spring (Q) into hole in idler 

arm (R).

•      Install belt onto engine pulley (M).

IMPORTANT: 

 Check belt for proper routing in all mower 

pulley grooves.

•      Raise attachment lift lever to highest position.
•     If necessary, adjust gauge wheels before op er at ing 

mower as shown in the Operation section of this 
manual.